Hier Klicken für das PDF Dokument!!!
GPHP SERIES SINGLE OUTPUT POWER SUPPLY
High Power Supplies 600/700 Watt AC/DC Universal Input Power Supply SUMMARY
· 90 -264 Vac nominal input range g
· Overvoltage and short circuit protection
· Approved to UL, CSA and EN Standards
· Power Good LED
· Low Leakage
The GPHP Series are universal input AC/DC power supplies
with power factor correction (PFC) with up to 700 Watts ouput
power. The GPHP product in corporates `hot-swap' capabilities
and a handle. The series is approved to EN60950 to reduce
design-in time and end system compliance costs
GPHP 600 shown in CRA rack
All specifications are typical at nominal input, full load at 25 OC unless otherwise stated SPECIFICATIONS
OUPUT SPECIFICATIONS INPUT SPECIFICATIONS
Output Power Integral forced air 700 Watts max. Input Voltage range Universal input 100-240 nom (85 - 264 max)
Total Regulation See table Vac
Rise time At turn-on 2.0 s max. Input frequency 47 Hz to 63 Hz
Transient response Main output 25% 3.5% max. dev. 350 ms recovery Input surge current 25 A max.
0.1 A/ms to 1% Ground Leakage current 264 Vac 60 Hz 160 mA
Temperature Coef- +/-0.03%/oC Input current 120 Vac 8.5 A
ficient 230 Vac 4.5 A
Overvoltage protection 125% +/-10% Input fuse F1,F2 10.0 A
Short Circuit protection block wall Yes
EMC INFORMATION ENVIRONMENTAL SPECIFICATIONS
Conducted emissions FCC Pt 15, EN55022 Level B Thermal Performance operating ambient -20 oC -50 oC
Radiated emissions FCC Pt 15, EN55022 Level A (see ratings chart)
Line freq. harmonics EN61000-3-2 Class A non-operating -40 to +85 oC
Voltage fluctuations EN61000-3-3 Complies (clause 5b) 0 - 50 oC 600 Watts
Convection cooled
ESD Air EN61000-4-2 8 kV contact
Maximum Altitude operating / non-operating 10,000 ft. / 40,000
ESD Contact EN61000-4-2 6 kV air ft. max.
Radiated immunity EN61000-4-3 3 V/m Relative Humidity non-condensing 5% - 95% RH
Fast Transients (EFT) EN61000-4-4 2 kV 5 kHz Vibration (operating) 0.003 g /Hz
2
1.5 grms 3 axes 10
min/axis
Line surge immunity EN61000-4-5 1 kV diff /2 kV cm
Vibration (non-operating) 0.026 g2/Hz 5.0 grms 3 axes, 1
Conducted immunity EN61000-4-6 3 Vrms hr/axis
Power freq. mag. field EN61000-4-8 3 A/m Shock half-sine 20 gpk 10 ms, 3 axes, 6
Voltage dip immunity EN61000-4-11 Unit will ride through without shocks total
loss of output at 75% of Shock half-sine 40 gpk 10 ms, 3 axes, 6
rated load with AC power fail shocks total
warning.
Page 1 of 3 CompuMess Elektronik GmbH · Lise-Meitner-Str.1 · 85716 Unterschleissheim
Tel 089-321501-0 · Fax 089-321501-11 · www.compumess.de · www.netzteile.de
GENERAL SPECIFICATIONS
Hold-up time 120 Vac, 60 Hz 30 ms at 600 Watts output
Efficiency 120 Vac 600 W output >84 %
isolation voltage input to ouput 4000 Vac
input to ground 1500 Vac
Switching frequency fixed 70 KHz, +/- 10 KHz
Safety Approvals UL/EN/IEC 60950-1 1st Edition CSA22.2 No.60950-1-03
Maximum weight 2 kg (4.4 lbs)
MODEL NUMBER Output Peak Output Features Ripple Regulation
GPHP600-24 24 V 25 A 24 V 27 A Hot Swap 240 mV 3% (see note 4)
GPHP600-28 28 V 21.5 A 28 V 23.5 A Hot Swap 240 mV 3% (see note 4)
GPHP600-36 36 V 17 A 36 V 19 A Hot Swap 240 mV 3% (see note 4)
GPHP700-48 48 V 14 A 48 V 15.6 A Hot Swap 240 mV 3% (see note 4)
NOTES
1. Integral forced air cooling
2. Peak rating is for 1 minute maximum 10% duty cycle
3. Noise measurent 20 MHz Bandwidth, differential mode. Measured with scope probe directly across output terminals of the power supply.
4. Regulation includes provision for `droop' sharing
MECHANICAL NOTES
The GPHP series is factory configured for rack mounting installation with Condor CRA series racks. Other mounting configurations and connector op-
tions are available, Please contact factory.
POWER CONNECTOR DIN # 41612 Type H
INPUT PINS
Z-32 AC Line
D-30 AC Neutral
Z-28, D26 GROUND
OUTPUT PINS
Z12, D14, Z16,D18 OUTPUT
Z4, D6, Z8, D10 RETURN (COMMON)
STATUS & CONTROL PINS
Z20 DC POWER GOOD
Z24 INHIBIT
D22 AC POWER FAIL
Page 2 of 3 CompuMess Elektronik GmbH · Lise-Meitner-Str.1 · 85716 Unterschleissheim
Tel 089-321501-0 · Fax 089-321501-11 · www.compumess.de · www.netzteile.de
OUTLINE AND MOUNTING DRAWING
Other drawings and SolidWorksTM 3D Models are available on request.
Condor DC Power Supplies Inc. 2311 Statham Parkway, Oxnard CA, 93033, USA. Phone:(805) 486 4565 Fax:(805) 487 8911 Email: condor@condordc.com
GPHP600/700 RevB 11/15/05.
Data Sheet © 2005 Condor DC Power Supplies Inc. The information and specifications contained in this data sheet are believed to be correct at time of publication. However, Condor accepts
no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice.
SolidWorks is a trademark of SolidWorks Corp.
Page 3 of 3
CompuMess Elektronik GmbH · Lise-Meitner-Str.1 · 85716 Unterschleissheim
Tel 089-321501-0 · Fax 089-321501-11 · www.compumess.de · www.netzteile.de