Hier Klicken für das PDF Dokument!!!
GPC225 Commercial/GPM225 Medical
225 Watt Global Performance Switchers
FEATURES:
· Wide-range ac input 85-264 Vac
· 2-year warranty
· Conducted EMI exceeds FCC Class B and CISPR 22
Class B (Commercial models) and CISPR 11 Class B
(Medical models)
· Commercial Approved to UL1950, IEC950 and
CSA22.2-234 L3
· Medical Approved to UL2601-1, IEC601-1 and
CSA22.2 No. 601
· marked to LVD
SPECIFICATIONS:
Ac Input
85-264 Vac, 47-63 Hz single phase. line impedance and distortion. Other settings are avail-
able to the user through adjustment of built-in potentiometer.
Input Current
Maximum input current at 120 Vac, 60 Hz with full rated Output Noise
output load: 5.5 A 0.5% rms, 1% pk-pk, 20 MHz bandwidth, differential
mode. Measured with noise probe directly across output
Hold-Up Time terminals of the power supply.
20 ms minimum from loss of ac input at full load, nominal
line (115 Vac). Transient Response
500 µs typical response time for return to within 0.5% of
Output Power final value for a 50% load step change. i/t<0.2 A/µs.
175 W convection; 225 W with 26 cfm air; 250 W peak. Peak Maximum voltage deviation is 3.5%. Startup/shutdown
ratings are for 60 s maximum duration, 10% duty cycle. overshoot less than 3%.
Overload Protection Remote Sense
Fully protected against short circuit and output overload. Provided as a standard feature.
Short circuit protection is cycling type power limit.
Recovery after fault is automatic. Factory set to begin Voltage Adjustment
power limiting at approximately 250 W. Built-in potentiometer adjusts voltage ±5%.
Overvoltage Protection EMI/EMC Compliance
124% ± 12% typical. All models include built-in EMI filtering to meet the
following emissions requirements:
Efficiency EMI SPECIFICATIONS COMPLIANCE LEVEL
70% at full rated load, nominal input voltage, depending Conducted Emissions GPC225 EN55022 Class B; FCC Class B
on model and load distribution. Conducted Emissions GPM225 EN55011 Class B; FCC Class B
Static Discharge EN61000-4-2, 6 kV contact, 8 kV air
Input Protection RF Field Susceptibility EN61000-4-3, 3 V/meter
Internal ac fuse provided. Designed to blow only if a Fast Transients/Bursts EN61000-4-4, 2 kV, 5 kHz
catastrophic failure occurs in the unit. Surge Susceptibility EN61000-4-5, 1 kV diff., 2 kV com.
Inrush Current Commercial Leakage Current
Inrush is limited by internal thermistors. Inrush at 240 Vac 0.95 mA 254 Vac @ 60 Hz input (with no deviations).
under cold start conditions will not exceed 60 A.
Commercial Safety
Temperature Coefficient Approved to UL1950, CSA22.2 No. 234 Level 3, IEC950,
0.03%/°C typical on all outputs. EN60950 and CISPR22. UL file #E135803 commercial;
CSA #LR46516. The output(s) are intended for safety
Thermal Shutdown earthed Signal Output and Intermediate Circuits only. All
Provided as a standard feature. Designed to protect unit dc outputs are SELV under normal and single fault
from prolonged over temperature. conditions.
Environmental Medical Leakage Current
Designed for 0 to 50°C operation at full rated output 60 µA. 254 Vac @ 60Hz input.
power; derate output current and total output power by
2.5% per °C above 50°C. See Environmental and Medical Safety
Packaging Specifications on next page. Approved to UL2601, CSA22.2 No. 601 Level 3 and
IEC601. UL file E116994; CSA #LR46516. The output(s)
Power Fail are intended for safety earthed Signal Output and
TTL- or CMOS-compatible output goes low (< 0.5 V) 5 ms Intermediate Circuits only. The output(s) are not accept-
before output voltage drops more than 4% below nominal able for patient connection without additional isolation. All
voltage upon loss of ac power. The signal is factory set to dc outputs are SELV under normal and single fault
trip on 84 to 94 Vac brown-out depending upon incoming conditions.
CompuMess Elektronik GmbH · Lise-Meitner-Str. 1 · D-85716 Unterschleißheim
Condor D.C. Power Supplies, Inc., 2311 15 01 - 0 ·Parkway,(089) 32 15 01 - 11
Telefon (089) 32 Statham Telefax Oxnard, CA 93033
66 800-235-5929 · 805-486-4565 · FAX 805-487-8911 · www.condorpower.com
info@compumess.de · www.compumess.de · www.netzteile.de
GPC225 Commercial/GPM225 Medical 225 Watt Multiple Output
Commercial Medical Output Output Output
Model Model Output Minimum Maximum (B) Maximum (C) Peak Noise P-P Total Regulation (A)
GPC225-5 GPM225-5 5V 0A 34 A 40 A 45 A 50 mV 2%
GPC225-12 GPM225-12 12 V 0A 15.8 A 19 A 20 A 120 mV 2%
GPC225-15 GPM225-15 15 V 0A 12.7 A 15 A 16 A 150 mV 2%
GPC225-24 GPM225-24 24 V 0A 8.3 A 9.4 A 10 A 240 mV 2%
GPC225-28 GPM225-28 28 V 0A 7.1 A 8A 8.5 A 280 mV 2%
A.Total regulation is defined as the maximum deviation from the nominal voltage for all steady-state conditions of initial voltage setting, input line voltage and output load.
B. Unrestricted natural convection cooling.
C. Requires 26cfm moving air.
GPC225/GPM225 MECHANICAL SPECIFICATIONS
Environmental
Operating Non-operating
Specification
Temperature (A) See individual specs -40 to +85oC
Humidity (A) 0 to 95% RH 0 to 95% RH
A. Units should be allowed to warm up/operate under non-condensing conditions
Shock (B) 20 gpk 40 gpk before application of power.
B. Random vibration--10 to 2000Hz, 6dB/octave roll-off from 350 to 2000Hz, 3
Altitude -500 to 10,000 ft -500 to 40,000 ft orthogonal axes. Tested for 10 min./axis operating and 1 hr./axis non-operating.
C. Shock testing--half-sinusoidal, 10 ± 3 ms duration, ± direction, 3 orthogonal axes,
2
Vibration (C) 1.5 grms, 0.003 g /Hz 5 grms, 0.026 g2/Hz total 6 shocks.
CompuMess Elektronik GmbH · Lise-Meitner-Str. 1 · D-85716 Unterschleißheim
Condor D.C. Power Supplies, 32 15 2311 Statham Parkway, Oxnard, CA 93033
Telefon (089) Inc., 01 - 0 · Telefax (089) 32 15 01 - 11
800-235-5929 · 805-486-4565 · FAX 805-487-8911 · www.condorpower.com 67
info@compumess.de · www.compumess.de · www.netzteile.de